The Reliance Controls 30 Amp power inlet box is designed for outdoor use and can be hardwired directly to Reliance Controls transfer switches or panels, eliminating need for cords running through windows or doors. This rain-tight, rust-proof unit includes an NEMA L14-30P inlet plug, six knockout holes, and push-in wire connections. Using one of the four combination 1/2-inch and 3/4-inch knockouts (one on each side, bottom and back), the power inlet box can be wired directly to the transfer switch or panel. The exclusive patented design provides generous wiring space and facilitates rough-in. The face of the box is removable for easy placement and wiring. It is cUL 1008 listed and covered by a 5-year warranty.

The Reliance Controls Corporation 6-circuit 30 Amp transfer switch is a complete turn-key kit with everything needed to make a professional transfer switch installation in a home or office. It is designed to enable the wiring system of the building to accept the full power of a portable generator, which can run multiple electrical appliances and devices during a power outage. Use this transfer switch for up to 7,500-watt generators equipped with NEMA L14-20 or L14-30 power outlets. The kit includes a 30A 6-circuit prewired loadside reliance transfer switch with wattmeters; 30 Amp outdoor power cord inlet box, a 30 Amp 10-foot generator power cord with L14-30 ends, and an extra L14-20 cord end for smaller generators. This unit is cUL1008 listed and is covered by a 5-year warranty.

The Reliance Controls single-circuit 15 Amp furnace transfer switch is designed for use with generators with 15 Amp power outlets. It controls a single circuit, such as a forced-air furnace, in the event of a power failure, connecting it to a portable generator. The attached 18-inch flexible aluminum conduit is pre-wired and allows the unit to be easily connected at the circuit breaker panel, the furnace, or at any point in between. It can be used on any 15 Amp 120-volt forced-air furnace circuit. Simply plug a standard grounded extension cord into a power outlet on your generator and into the built-in plug on the transfer switch. It includes an indicator light, which illuminates the area around its switch during a power outage. This unit is UL listed and is covered by a 5-year limited warranty.

This economical single-load transfer panel provides safe single-load transfer from generator to an office, garage or farm building where the entire circuitry is to be powered by a generator during a power outage. Compact, all-steel design completely isolates the generator from the utility with manual switching action. Can be used as an economical alternative to a DPDT switch. Maximum generator input is 15,000 Watts. Indoor surface-mount design. Can also be used for tractor-driven farm PTOs. UL listed. 5-year limited warranty. U.S.A. Factory shipped.

Safest Way to Distribute Power Eliminates dangerous backfeeds and electrical overload...

The GenTran 30 Amp 8-circuit transfer switch for up to 7,500-watt generators includes everything you'll need to install a generator transfer switch for safe, convenient portable generator hookup. Power up your essential circuits using a 5,000-watt generator (continuous watts) during a power outage or emergency. It accommodates 8-to-10 household circuits like your furnace blower (gas only), refrigerator and kitchen circuits, well pump, lights, and television. If your needs change, your installer can easily expand this transfer switch to up to ten circuits just by adding more circuit breakers. The enclosure can be surface mounted indoors, and allows hardwired or plug-in generator connections. Because it was designed with off-the-shelf circuit breakers you don't have to search high and low for replacements, and your installer can reconfigure the breaker combinations to suit your family's needs.

This transfer switch includes a L14-30 male power inlet and a dual watt meters to help you balance generator loads to prolong generator life. The kit comes with two 15 Amp 1-pole breakers, two 20 Amp 1-pole breakers, one 2-pole 20 Amp breaker, and one 2-pole 30 Amp breaker. A 60 Amp 2-pole main breaker is required in existing load center (not included). This kit comes with a 2-year limited warranty.

The Reliance Controls Corporation 10-circuit 30 Amp transfer switch kit is a complete turn-key kit with everything needed to make a professional transfer switch installation in a home or office. It is designed to enable the wiring system of the building to accept the full power of a portable generator, which can run multiple electrical appliances and devices during a power outage. Use this transfer switch for up to 7500-watt generators equipped with NEMA L14-20 or L14-30 power outlets. The kit includes a 30 Amp 6-circuit prewired loadside reliance transfer switch with wattmeters; 30 Amp outdoor power cord inlet box, a 30 Amp 10-foot generator power cord with L14-30 ends, and an extra L14-20 cord end for smaller generators. This unit is cUL1008 listed and is covered by a 5-year warranty.

The Reliance Controls 20 Amp power inlet box is designed for outdoor use and can be hardwired directly to Reliance Controls transfer switches or panels, eliminating need for cords running through windows or doors. This rain-tight, rust-proof unit features zinc-plated steel construction. It includes an NEMA L14-20P inlet plug, six knockout holes, and push-in wire connections. The face of the box is removable for easy placement and wiring. It is cUL 1008 listed and covered by a 5-year warranty.

The industry's most versatile manual transfer switch. 6 circuits, 30 amps, for generators up to 7500 watts. All wires, conduit, fittings and wire connectors included. Copper bus. Expandable to 16 circuits using standard interchangeable type breakers. Reconfigure the circuit breakers to accommodate your needs. Can be surface or flush mounted indoors. Accommodates hardwiring to generator or installed with a plug-in cord connection. Ships with Siemens breakers, but also UL Listed with Cutler-Hammer BR, Square D HOM, and GE THQL breakers. Accommodates arc fault and GFCI breakers. UL 1008 Listed.

50 amp Raintite Power Inlet Box for generators up to 12,500 watts. NEMA 3R-rated aluminum enclosure includes 4-wire, 50A 120/240V male inlet in configuration CS 6365 on bottom. Use with 50 Amp female connector in configuration CS6364 (our model RJBC6364). Maintains "raintight" rating when cord is connected, required by most inspectors. Made in USA. UL Listed.